Have a new Honda GCV 160? This guide will walk you through starting and stopping this engine, as well as address common issues, no matter what it may be powering. download 1993 Mariner 150 Hp Outboard Manual torrent here. Before Use Fuel – Make sure there is fresh gasoline in the tank. This engine can use fuel blended with up to 10% ethanol (E10) or 5% methanol. Do not fill past the bottom of the filler neck. Oil – Remove the oil filler cap/dipstick, wipe it clean, and reinsert it into the filler neck without screwing it in. download Ezgo Rxv 2018 Service Manual.
Pull it out and check for oil. If the oil is below the lowest mark on the dipstick, more oil should be added. Honda recommends 10W30 motor oil for this engine. download free 2018 Mercury 75 Elpto Manual. Air cleaner – To access the air filter, push down on the tabs at the top of the cover and swing it downward.
Check the filter element for damage. If the filter is dirty, tap it against a hard surface to loosen the dirt. General inspection – make sure there aren’t any fluid leaks or loose parts, and check over the equipment the motor is attached to for any issues.
Suzuki Gsf 1250 Sa Owners Manual download. Starting and Stopping Engines There are several versions of this engine with different starting and stopping procedures, but there a few things that remain the same across the model range: • The fuel valve must be opened before starting the engine and closed after stopping the engine. • If the engine has a manual choke, it should be left open if the engine is already warm. • To use a recoil-starter, pull the starter grip until resistance is felt, then give it a hard pull to turn over the engine.